What temperature should I cook a ham?
- For raw, fresh ham, the USDA advises cooking to an internal temperature of 145°F. The higher the ham cooks above 145°F, the drier the flavor and texture.
How do I cook a precooked ham?
Preheat the oven to 350 F.
Place the ham on a rack in a large baking pan and add about 1/4-inch to 1/2-inch of water to the pan.
If the ham is labeled ‘fully cooked’ (does not require heating), heat it in the oven for about 10 minutes per pound, or to an internal temperature of 140 F.
How long does it take to cook a ham?
Put the ham, flat-side down, on a rack in a roasting pan. Pour 1/4 inch water into the bottom of the pan. Transfer to the oven and roast until a thermometer inserted into the thickest part of the ham registers 130 degrees F, about 2 hours, 30 minutes (about 15 minutes per pound).
How long does it take to cook a 10 pound ham?
Preheat the oven to 325°F. Place the ham on a rack in a shallow roasting pan. For a whole 10- to 15-pound ham, allow 18 to 20 minutes per pound; for a half–5 to 7 pounds–about 20 minutes per pound; or for a shank or butt portion weighing 3 to 4 pounds, about 35 minutes to the pound.
Do you put water in pan when cooking ham?
Cover the ham with foil or use a baking bag to heat up the ham until it’s time to glaze. You can also add a little bit of liquid, like wine or water, to the bottom of the baking pan for some additional moisture.
How do you warm up a cooked ham?
Reheat in a 325-degree oven until it reaches an internal temperature of 135 to 140 degrees. You can also place the ham in an oven bag. Figure no more than 10 minutes per pound for reheating. For hams that are fully cooked (again, check the label) and not spiral sliced, first cut off any skin.
How can you tell if a ham is done without a thermometer?
Press the tip of your index finger to the tip of your thumb. The fleshy area below the thumb should give quite a bit. This is what meat cooked to rare feels like. Open up your palm again and compare raw to rare.
How can you tell if ham is cooked?
An instant read thermometer is used to check for the proper temperature once the ham has been cooked. The ham is taken away from the heat source and the instant read thermometer is immediately inserted into the thickest part of the ham and it will give a temperature reading in approximately 15 seconds.
Do you have to heat up a fully cooked ham?
A fully cooked, ready-to-eat ham (also referred to as a “city ham”) can be sliced and served cold or at room temperature—there’s no need to reheat it.
What temp should ham be cooked to?
NOTE: Set oven temperature to 325 °F. Cook all raw fresh ham and ready-to-eat ham to a minimum internal temperature of 145 °F as measured with a food thermometer before removing meat from the heat source. For safety and quality, allow meat to rest for at least three minutes before carving or consuming.
How do you cook a fully cooked Smithfield ham?
Heat oven to 325 degrees F. Remove all packaging materials and place ham on its side, fat side up, on rack in shallow roasting pan; cover loosely with aluminum foil. 2. Heat approximately 15 to 20 minutes per pound until heated through.
How long does it take to cook a 10 lb frozen ham?
Heat your oven to 325°, then carefully place the ham in a roasting pan with an inch of water inside. Calculate the time needed for your ham to cook in the oven based on its weight. The rule of thumb is to cook for 18 to 20 minutes per pound.
How do you heat a spiral ham?
Spiral Sliced Hams
Place the ham cut-side-down on heavy-duty aluminum foil and wrap the ham thoroughly. Or, use an oven roasting bag; follow instructions on the bag for preparation. Bake in a preheated 325 F oven for 10 to 14 minutes per pound or until a meat thermometer registers 140 F.